NSTP Home Certification SBCA Home
Tech Support Recertification NSTP Store
About NSTP F.A.Q. Contact Us
Satellite Fundamentals MDU/SMATV Essentials MFH2 Technology FOXCOM Fiber Optics

DIRECTV COM1000 Certification

 

 

The objective of this course is to educate students on the DIRECTV COM1000 HD system designed for MDU applications.  The course covers the entire process of system equipment, design, installation, and troubleshooting.  Upon completion of this course students should be able to:

  • Know proper COM24 card setup procedures
  • Know proper setup procedures for the Harmonic Edge QAM controller in relation to the COM1000 system
  • Know ramifications of improperly installed outside plant equipment
  • Understand troubleshooting steps to solve basic issues
  • Have demonstrated skill sets through hands on lab sessions
  • Be able to set up a laptop to provision a COM1000 system
  • Recognize spectrum limitations and QAM channel limitations
  • Define what PRO:IDIOM encryption is and its use in this application
Who should take this class?
  • All commercial MDU system installation technicians who install DIRECTV COM1000 systems.

    • Recommended Prerequisites:

  • SBCA Satellite Fundamentals

  • SBCA MDU/SMATV Essentials

    • Recommended Knowledge:

  • Thorough understanding of RF Distribution
  • Ability to calculate specific equations regarding signal loss
  • Understand the principles of OHM's Law
  • Understand the principle of Watt's Law
  • Understand the principles of Volt's Law
  • Ability to perform BTU calculation
  • Understanding of the current NEC code
  • Knowledge of all relevant SCTE symbols
  • Understanding of cable attenuation
  • Knowledge of frequency guides

    • SBCA members that have received a $50 coupon toward SBCA certification in their welcome packets can redeem one for this course.  The coupon must be presented to the trainer prior to taking the course.  Not a member?  JOIN NOW!

    COM1000 In-Class Certification

    Click HERE if the schedule does not display.

    		 The COM1000 Certification Course is presented exclusively by PDI-SAT. 

    Cost: $299.00

    • 1 Day Course, with the test given at the end of the day
    • An 85% or better is needed to pass
    • 1 Free retake is available should the tech not pass.  This is a retake of the test only.  A fee may be applied should the technician wish to sit through the course again.  If you are a technician seeking a retake, locate a course convenient to you and contact the trainer to inform them you need to take a retake.